usr /lib /ddns /dynamic_dns_updater.sh myddns 0 & Monitoringĭdns-scripts have built-in logfile support. To start your configuration via build in crond use the following entry as command inside crontab configuration (replace myddns with the name of your configuration/section): To guarantee that your configurations only run once not looking for an interface event you need to disable ddns service. The configuration/section configured to run once will stop after successful update. If you set ddns service to enable then all configurations/sections are started during interface ifup. Inside LuCI set Force Interval in Timer Settings tab of your desired configuration or edit /etc/config/ddns on console. To configure your configuration/section to run once you need to set option force_interval 0.
#DYN UPDATER SAYS DISABLED UPDATE#
To stop one configuration/section you need to list running ddns processes with:Įach configuration/section of ddns-scripts can be configured to run once including retry on error so it is guaranteed that the update is sent to the provider.
Sh /usr /lib /ddns /dynamic_dns_functions.sh # note the leading period followed by a space To start all ddns-scripts configurations configured for one interface (the interface name from /etc/config/network, usually 'wan'): usr /lib /ddns /dynamic_dns_updater.sh myddns 0 & To start only one ddns-scripts configuration/section (here myddns): firewall) might be (re-)started via ifup hotplug event!įor INTERFACE, type the specified ddns-scripts interface name (the interface name from /etc/config/network, usually 'wan')ĪCTION= ifup INTERFACE=wan /sbin /hotplug-call iface Keep in mind that also other service processes (i.e. This will start all enabled ddns configurations/sections monitoring this interface. Users reported timeout problems, use links in the line below (…:8245).įrom console command line you could create an ifup hotplug event for the desired network interface. Uci commit ddns # don't forget this, otherwise data not written to configuration file Uci set = set = "wan" # network interface that should start this configuration/section
Uci set _name= "" # only use names listed in /usr/lib/ddns/services # or /usr/lib/ddns/services_ipv6 (since CC 15.05) Other editors as vi needs to be installed separately.Īlternatively you can use UCI command line interface. The easiest way to configure ddns-scripts via console is to edit the file /etc/config/ddns directly using build-in vi editor or any other editor you prefer.
0 kommentar(er)
